| PROBLEM |
CAUSE |
SOLUTION |
| Turntable
does not start to rotate. |
The infeed safety photoeye may
be blocked or dirty. |
Clear the photoeye and/or clean
it. |
| The outfeed safety photoeye may
be blocked or dirty. |
Clear the photoeye and/or clean
it. |
| Turntable speed on the control
panel is set to zero (0) or too low for the table to turn. |
Increase the turntable speed
setting. |
| Motor fuses may be burned. |
Check for short, if none change
the fuse using the adequate rating. |
| Pinion key is broken. |
Check rotation mechanism, if
in proper order, change the key. |
| Machine
stops in the middle of a cycle. |
Infeed safety photoeye may have been blocked. |
Clear the photoeye and / or
clean it. |
| The outfeed safety photoeye may have been blocked. |
Clear the photoeye and / or clean
it. |
| One of the emergency stops may have been depressed. |
Pull emergency stop back out. |
