| PROBLEM |
CAUSE |
SOLUTION |
| 1st
infeed conveyor does not start. |
There was no signal received
by the Wulftec system.
|
Look for related input on the
PLC. |
| The system is not in "start
state". |
Look for the blue light on control
panel. |
| Emergency stop might be depressed. |
Pull emergency stop back. |
| Load
does not stop centered. |
The system may be set in the
passthrough mode. |
Turn the passthrough switch
located on the control panel to wrapping mode. |
| The center photoeye may not see
the load. |
Clear the photoeye and / or clean
it. |
| The infeed safety photoeye may
not see the load. |
Clear the photoeye and / or clean
it |
