| PROBLEM |
CAUSE |
SOLUTION |
| The
reset sequence does not stop. |
Arm
is not at home position and is not turning. |
See
Arm not turning problem. |
| Arm
is turning but does not stop at home position. |
Check
if min. speed is set too high and proximity sensor adjustment. |
| Push
arm may not be completely retracted. |
See
Push
arm not moving problem. |
| Power
light is not on |
Main
fuse is OFF. |
Turn
on the main fuse. |
| Light
bulb may be burned out. |
Change
the light bulb. |
| Main
switch is in the OFF position. |
Turn
the switch to the on position. |
| Main
fuses are burned. |
Check
for short. If none, change the main fuse using the right rating. |
| Related
glass fuse is burned. |
Check
for short. If none, change the fuse using the right rating. |
| Start
(Blue) light does not come on after pushing on start. |
Light
bulb may be burned out. |
Change
the light bulb. |
| An
alarm may be activated. |
Accept
the alarm. |
| One
of the automatic modes was not engaged. (Wrapping or Passthrough) |
Make
sure that the machine is in automatic mode and that a reset was
done. |
| The
infeed safety photoeye may be blocked or dirty. |
Clear
the photoeye and / or clean it. |
| The
outfeed safety photoeye may be blocked or dirty. |
Clear
the photoeye and / or clean it. |
| Auto
light will not stop flashing in reset mode. |
Turntable
is stopped somewhere other than home position. |
See
Turntable
does not start to rotate. |
| Turntable
does not stop at home position. |
Check
if min. speed is set too high and proximity sensor adjustment. |
| Automatic
light does not come on after reset |
Light
bulb may be burned out. |
Change
the light bulb. |
| Passthrough
switch may be engaged. |
Switch
the passthrough switch to off. |
| Switch
not set to automatic. |
Set
switch to auto and activate "RESET" once
more. |
| Related
glass fuse is burned. |
Check
for short, if none change the fuse using the right rating. |
| Breaker
Problem |
Overload
- short of wire - defective drive. |
Check
for short. If none found turn breaker on for one time. If the
breaker jumps again, contact
us. |
| Fuses
problem |
Overload
- short of wire - defective drive. |
Check
for short. If none found change fuse for one time. If the fuse burns
again, contact us. |
